Finished Dimensions:
7 3/4" H x 14" W x 12 1/4 " D
Notes:
This charging station was built using scraps I had on hand. The measurements below, reflect the measurements of those scraps. This plan could be modified to suit a variety of material thicknesses. Please make any necessary adjustments for material widths before cutting out your pieces.
Warning: Some chargers and devices produce quite bit of heat. Build at your own risk.
Notes:
This charging station was built using scraps I had on hand. The measurements below, reflect the measurements of those scraps. This plan could be modified to suit a variety of material thicknesses. Please make any necessary adjustments for material widths before cutting out your pieces.
Warning: Some chargers and devices produce quite bit of heat. Build at your own risk.
**There may be a tutorial or additional plans for using new wood in the future, please check back.**
Materials:
- Scraps, I used scrap 1 x10 boards, 1/4" ply and some hobby boards.
- glue
- nails
- 2 small hinges
Cut List:
From 3/4 " plywood or board
From 1/4" ply
From 3/8 ply or board
From 3/4 " plywood or board
- 2-7 3/4" x 12 1/4" (will become sides)
- 1 -5 3/4" x 13" middle shelf
- 1 - 9 7/8" x 13 bottom shelf
From 3/8 ply or board
- 3 3/4" x 12 1/2" back
- 1 - 4" x 12 3/8" top shelf
- 2 - 3 3/4 x 3 7/8 dividers
No comments:
Post a Comment
Thank you for visiting and taking the time to comment. I moderate all comments. Please allow up to 24 hrs. for your comment to appear.
- Amy